 |
| Board, Arduino, XBEE Shield, w/o module |
The device here is used to mount the Xbee module onto the Arduino UNO. On the far left of the device in the picture, there is a cap for 2 pins. This cap here is for the 3 pins on this Xbee Shield. Naming the pins '1', '2', '3' from left to right, covering '1' and '2' will set the shield to 'USB' mode and covering '2' and '3' will set it to 'XBEE' mode. From what we found out/ read online, the 'USB' mode allows configuration of the Xbee module. In other words, we can say that information can only be passed around from the USB using the A-B USB Cable. The 'XBEE' mode should also work the same way where information can only be passed around from the Xbee module attached to the Xbee Shield.
No comments:
Post a Comment